LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Manual Transaxle & Differential (5MT)) >> Reverse Idler Gear >> Removal

Reverse Idler Gear: Removal

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the manual transmission assembly from the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>MANUAL TRANSMISSION ASSEMBLY>REMOVAL .
  2. Remove the back-up light switch and the neutral position switch. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>SWITCHES AND HARNESS>REMOVAL .
  3. Remove the transfer case together with the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>REMOVAL .
  4. Remove the transmission case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>TRANSMISSION CASE>REMOVAL .
  5. Remove the drive pinion shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>DRIVE PINION SHAFT ASSEMBLY>REMOVAL .
  6. Remove the main shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>MAIN SHAFT ASSEMBLY>REMOVAL .
  7. Remove the front differential assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>FRONT DIFFERENTIAL ASSEMBLY>REMOVAL .
  8. Remove the shifter forks and rods. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>SHIFTER FORK AND ROD>REMOVAL .
  9. Pull out the straight pin, and remove the reverse idler gear shaft, adjusting washer, reverse idler gear and washer.
    G13604409Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the reverse shifter lever.
scientia non olet · About LEMON Manuals