LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Service Information) >> Evaporator >> Removal

HVAC System (Heater, Ventilator And A/C) (Service Information): Evaporator: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to CAUTION , General Description.
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to BATTERY
    NOTE: Repair Contents.
  2. Remove the heater and cooling unit assembly. Ref. to REMOVAL , Heater and Cooling Unit.
  3. Pull out the heater core. Ref. to REMOVAL , Heater Core.
  4. Remove the screws, and remove the duct - foot assist.
    Fig 1: Identifying Foot Duct Screws
    G10276815Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the heater case lower.
    1. Remove the clip, and remove the connector.
    2. Remove the packing.
    3. Remove the screw and lock, then remove the heater case lower.
    Fig 2: Identifying Heater Case Lower Screws And Lock
    G06652989Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the evaporator.
    Fig 3: Removing Evaporator
    G07914490Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the expansion valve - cooling. Ref. to REMOVAL , Expansion Valve.
  8. Remove the evaporator sensor. Ref. to REMOVAL , Evaporator Sensor.
scientia non olet · About LEMON Manuals