LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle & Differential (TY85) (WRX-STI)) >> Drive Pinion Shaft Assembly >> Installation

Drive Pinion Shaft Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove any remaining gasket material from the drive plate and clutch housing.
  2. Apply liquid gasket to the clutch housing.

    Liquid gasket: 

    THREE BOND 1215B or equivalent 

    Fig 1: Identifying Liquid Gasket Applying Area To Clutch Housing
    G05003353Courtesy of SUBARU OF AMERICA, INC.
  3. Install the individual gear assemblies. < Ref. to INSTALLATION , Main Shaft Assembly. >
  4. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  5. Install the center differential. < Ref. to INSTALLATION , Center Differential. >
  6. Install the transfer driven gear. < Ref. to INSTALLATION , Transfer Driven Gear. >
  7. Install the extension case. < Ref. to INSTALLATION , Extension Case. >
  8. Install the neutral position switch, back-up light switch and harness. < Ref. to INSTALLATION , Neutral Position Switch. > < Ref. to INSTALLATION , Back-up Light Switch. >
  9. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals