LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transaxle & Differential (TY85) (STI)) >> Drive Pinion Shaft Assembly >> Removal

Drive Pinion Shaft Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission assembly from the vehicle. <Ref. to REMOVAL , Manual Transmission Assembly.>
  2. Prepare the transmission for overhaul. <Ref. to PREPARATION FOR OVERHAUL .>
  3. Remove the neutral position switch, back-up light switch and harness. <Ref. to REMOVAL , Neutral Position Switch.> <Ref. to REMOVAL , Back-up Light Switch.>
  4. Remove the extension case. <Ref. to REMOVAL , Extension Case.>
  5. Remove the transfer driven gear. <Ref. to REMOVAL , Transfer Driven Gear.>
  6. Remove the center differential. <Ref. to REMOVAL , Center Differential.>
  7. Remove the transmission case. <Ref. to REMOVAL , Transmission Case.>
  8. Remove the individual gear assemblies. <Ref. to REMOVAL , Main Shaft Assembly.>
  9. Remove the drive pinion shaft assembly.
Fig 1: Removing Drive Pinion Shaft Assembly
G05003473Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals