Transmission Rear CROSSMEMBER And Rear Cushion Rubber
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ground cable from the battery.
- Jack-up the vehicle and support it with rigid racks.
- Remove the center and rear exhaust pipes and the muffler. (Turbo model)
< Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- Remove the front exhaust pipe, rear exhaust pipe and muffler. (Non-turbo model) < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- Remove the heat shield cover.
- Set the transmission jack under transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
- Remove the transmission rear crossmember.
- Remove the rear cushion rubber from transmission.