LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Exhaust (H6DO)) >> Front Exhaust Pipe >> Removal

Front Exhaust Pipe: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  2. Lift-up the vehicle.
  3. Remove the under cover.
  4. Remove the front oxygen (A/F) sensor connector (A) and rear oxygen sensor connector (B).
    Fig 2: Identifying Front Oxygen (A/F) Sensor Connector And Rear Oxygen Sensor Connector
    G05018833
  5. Separate the front exhaust pipe from the rear exhaust pipe.
    CAUTION: Be careful, exhaust pipe is hot.
    Fig 3: Locating Front Exhaust Pipe Bolts
    G05018834
  6. Remove the nuts which hold front exhaust pipe onto cylinder heads.
    CAUTION: Be careful not to pull down the front exhaust pipe assembly.
    Fig 4: Locating Nuts Holding Front Exhaust Pipe Onto Cylinder Heads
    G05018835
  7. Remove the bolts which hold front exhaust pipe assembly to hanger bracket.
    Fig 5: Locating Bolts Holding Front Exhaust Pipe Assembly To Hanger Bracket
    G05018836
  8. Remove the front exhaust pipe assembly from vehicle.
    CAUTION:
    • Be careful not to let the front exhaust pipe assembly fall off when removing, since it is very heavy.
    • After removing the front exhaust pipe assembly, do not apply excessive pulling force on the rear exhaust pipe.
  9. Separate the front exhaust pipe (RH) from front exhaust pipe assembly.
    Fig 6: Locating Front Exhaust Pipe Nuts
    G05018837
  10. Remove the front oxygen (A/F) sensor and rear oxygen sensor. < Ref. to REMOVAL , Front Oxygen (A/F) Sensor. > < Ref. to REMOVAL , Rear Oxygen Sensor. >
scientia non olet · About LEMON Manuals