LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Exhaust (H4DOTC) >> Center Exhaust Pipe >> Removal

Center Exhaust Pipe: Removal

  1. Set the vehicle on a lift.
  2. Remove the collector cover.
  3. Disconnect the ground cable from battery.
  4. Remove the intercooler. < Ref. to REMOVAL , Intercooler. >
  5. Remove the intercooler bracket.
    Fig 1: Locating Intercooler Bracket Nut
    G05018247
  6. Lift-up the vehicle.
  7. Remove the under cover.
  8. Remove the bolts which install the lower side of turbocharger lower cover.
    CAUTION: Be careful, the turbocharger and exhaust pipe are hot.
    Fig 2: Locating Bolts On Lower Side Of Turbocharger Upper Cover
    G04998820
  9. Lower the vehicle.
  10. Remove the turbocharger upper cover.
    Fig 3: Identifying Turbocharger Upper Cover
    G04998821
  11. Remove the bolts which hold the turbocharger lower cover and center exhaust pipe.
    Fig 4: Locating Bolts Which Hold Turbocharger Lower Cover And Center Exhaust Pipe
    G04998822
  12. Separate the center exhaust pipe from turbocharger.
    Fig 5: Identifying Center Exhaust Pipe Nuts
    G04998823
  13. Lift-up the vehicle.
  14. Disconnect the connector from the rear oxygen sensor.
    Fig 6: Identifying Connector
    G05018252
  15. Separate the center exhaust pipe from rear exhaust pipe.
    Fig 7: Locating Center Exhaust Pipe Nut
    G05018253
  16. Remove the bolt which holds center exhaust pipe bracket to transmission.
    Fig 8: Locating Bolt Which Holds Center Exhaust Pipe Bracket To Transmission
    G05018254
  17. Remove the intercooler bracket.
  18. Remove the bolt which holds center exhaust pipe to hanger bracket.
    CAUTION: Be careful not to pull down the center exhaust pipe.
    Fig 9: Locating Bolt Which Holds Center Exhaust Pipe To Hanger Bracket
    G05018255
  19. Remove the center exhaust pipe.
    Fig 10: Removing Center Exhaust Pipe
    G04998829