LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical (H4SO)) >> Cam shaft >> Removal

Cam shaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove V-belt. < Ref. to INSTALLATION , V-BELT. >
  2. Remove crankshaft pulley. < Ref. to REMOVAL , CRANKSHAFT PULLEY. >
  3. Remove timing belt cover. < Ref. to REMOVAL , TIMING BELT COVER. >
  4. Remove timing belt. < Ref. to REMOVAL , TIMING BELT. >
  5. Remove camshaft sprocket. < Ref. to REMOVAL , CAMSHAFT SPROCKET. >
  6. Remove crankshaft sprocket. < Ref. to REMOVAL , CRANKSHAFT SPROCKET. >
  7. Remove belt cover No. 2 (LH).
  8. Remove belt cover No. 2 (RH).
    NOTE: Do not damage or lose the seal rubber when removing belt covers.
    Fig 1: Identifying Timing Belt Seal Cover
    G04997681Courtesy of SUBARU OF AMERICA, INC.
  9. Remove tensioner bracket.
    Fig 2: Identifying Tensioner Bracket
    G04997682Courtesy of SUBARU OF AMERICA, INC.
  10. Remove camshaft position sensor support. (LH side only)
  11. Remove oil level gauge guide. (LH side only)
  12. Remove valve rocker assembly. < Ref. to REMOVAL , VALVE ROCKER ASSEMBLY. >
  13. Remove camshaft cap.
    1. Remove bolts (a) through (b) in alphabetical sequence.
      Fig 3: Identifying Camshaft Cap Bolts (a through b)
      G04988320Courtesy of SUBARU OF AMERICA, INC.
    2. Equally loosen bolts (c) through (j) all the way in alphabetical sequence.
      Fig 4: Identifying Camshaft Cap Bolts (c through j)
      G04988321Courtesy of SUBARU OF AMERICA, INC.
    3. Remove bolts (k) through (p) in alphabetical sequence using ST.

      ST 499497000 TO RX® PLUS

      Fig 5: Identifying Camshaft Cap Bolts (k through p)
      G04988322Courtesy of SUBARU OF AMERICA, INC.
    4. Remove camshaft cap.
      Fig 6: Identifying Camshaft Cap
      G04988323Courtesy of SUBARU OF AMERICA, INC.
  14. Remove camshaft.
  15. Remove oil seal.
  16. Remove plug from rear side of camshaft.
    CAUTION:
    • Do not remove oil seal unless necessary.
    • Do not scratch journal surface when removing oil seal.
scientia non olet · About LEMON Manuals