Remove/install front differential mount on rear axle carrier - AR35.10-P-0051EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212, 218

Fig 1: Front Differential Mount On Rear Axle Carrier Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove left and right rear diagonal strut	MODEL 212.2, 218.9
1	Remove left and right rear diagonal strut	Bolt, rear diagonal strut bracket mount to body	*BA61.10-P-1006-01H
2	Remove exhaust system as from connecting point	MODEL 212, 218
		MODEL 212, 218 with ENGINE 157, 276, 278	AR49.10-P-7100EL
		MODEL 212 with ENGINE 156, 272, 273	AR49.10-P-7100EW
		MODEL 212, 218 with ENGINE 642, 651	AR49.10-P-7100EWI
		MODEL 212 with ENGINE 274	AR49.10-P-7100MR
3	Lower rear axle		AR35.10-P-0015EW
4	Detach rear axle differential (50) from differential mount (8)	The spacer ring (9) must be installed again.
4		Rear axle differential to front adapter	*BA35.10-P-1005-01N
5	Detach differential mount (8) from rear axle carrier (4) and remove	Bolt, adapter to front transverse bridge	*BA35.10-P-1004-01N
6	Install in the reverse order

REAR AXLE CARRIER

Number	Designation		MODEL 212	MODEL 218
BA35.10-P-1004-01N	Bolt, adapter to front transverse bridge	Nm	150	150

REAR AXLE CARRIER

Number	Designation		MODEL 212	MODEL 218
BA35.10-P-1005-01N	Rear axle differential to front adapter	Nm	65	65

FRAME FLOOR ASSEMBLY

Number	Designation		MODEL 212	MODEL 218
BA61.10-P-1006-01H	Bolt, rear diagonal strut bracket mount to body	Nm	60	60