Remove/install belt pulley/vibration damper - AR03.30-P-1600EWS
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 272, 273 in MODEL 212
| Remove/install | |||
| 1 | Turn key in ignition lock to position "0" | ||
| 2 | Remove front engine cover | See "Remove air filter housing" | |
| AR09.10-P-1150EWS | |||
| 3 | Remove poly-V belt | AR13.20-P-0001EWS | |
| 4 | Install retaining lock for crankshaft/starter ring gear | AR03.30-P-5000EWS | |
| 5 | Remove center bolt (3) | ||
| *BA03.30-P-1001-01M | |||
| 6 | Detach belt pulley/vibration damper (2) from crankshaft | ||
| Check | |||
| 7 | Check contact surface of crankshaft radial sealing ringing ring (5) at hub of belt pulley/vibration damper (2) | ||
| 8 | Replace front crankshaft radial sealing ringing ring (5) | When replacing the belt pulley/vibration damper (2) or in the event of leakage on the crankshaft radial sealing ringing ring (5) | |
| AR03.20-P-3000EWS | |||
| 9 | Install in the reverse order | ||
| Check | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 10 | Perform an engine test run and check engine for leaktightness |
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | ENGINE 272 | ENGINE 273 | ||
|---|---|---|---|---|---|
| BA03.30-P-1001-01M | Center bolt, belt pulley to crankshaft | Stage 1 | Nm | 200 | 200 |
| Stage 2 | ∠° | 90 | 90 | ||