Installation [07/2015 - ]: Procedure

INSTALL HAZARD FLASHER
1. Install the hazard flasher.
2. Install the screw.
3. Install the following parts:
  1. Center lower panel
    Refer to PROCEDURE - Step 1
  2. Driver-side lower panel
    Refer to PROCEDURE - Step 1
  3. Fuel-filler lid opener lever
    Refer to INSTALLATION [07/2015 - ]
  4. Hood release lever
    Refer to INSTALLATION [07/2015 - ]
  5. Front side trim (RH)
    Refer to PROCEDURE - Step 1
  6. Front scuff plate (RH)
    Refer to PROCEDURE - Step 1
  7. Center panel
    Refer to PROCEDURE - Step 1
  8. Glove compartment
    Refer to PROCEDURE - Step 1
  9. Rear console
    Refer to PROCEDURE - Step 1
  10. Side wall
    Refer to PROCEDURE - Step 1
  11. Front console
    Refer to PROCEDURE - Step 1
  12. Disc player
    Refer to PROCEDURE - Step 1
  13. Front console box
    Refer to PROCEDURE - Step 1
  14. Console side panel
    Refer to PROCEDURE - Step 1
  15. Shift panel
    Refer to PROCEDURE - Step 1
  16. Selector lever knob (ATX)
    Refer to INSTALLATION [07/2015 - ]
  17. Shift lever knob (MTX)
    Refer to PROCEDURE - Step 1
  18. Upper panel
    Refer to PROCEDURE - Step 1
  19. Shift bezel
    Refer to PROCEDURE - Step 1
  20. Center console tray
    Refer to PROCEDURE - Step 1
4. Connect the negative battery cable.
  Refer to PROCEDURE - Step 1