Rear Center Seat Outer Belt Assembly: Removal

CAUTION: Always use "TORX" socket wrench E10 when removing the rear seat.

REMOVE DECK BOARD SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 1 REAR SEAT LEG COVER (See REMOVAL )
REMOVE REAR SEAT ASSEMBLY RH (See REMOVAL )
REMOVE REAR DOOR SCUFF PLATE RH (See REMOVAL )
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH (See REMOVAL )
REMOVE REAR DECK TRIM COVER (See REMOVAL )
REMOVE REAR SEAT OUTER BELT ASSEMBLY RH (See REMOVAL )
REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (See REMOVAL )
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (See REMOVAL )
REMOVE ROOF SIDE INNER GARNISH RH (See REMOVAL )
REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY
1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and open the slip joint cover.
  
  Fig 1: Disengaging Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt and the through anchor.
  
  Fig 2: Locating Anchor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the bolt, the hook and the bracket.
  
  Fig 3: Locating Hook And Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the bolt, the 2 hooks and the retractor.
  
  Fig 4: Locating Hooks And Retractor With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE SEAT BELT ANCHOR COVER
1. Using a molding remover, disengage the 4 claws and remove the seat belt anchor cover.
  
  Fig 5: Identifying Seat Belt Anchor Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE SHOULDER BELT ANCHOR COVER RH
1. Remove the rear seat shoulder belt cover.