REAR SEAT ASSEMBLY (for RH Side): Removal

NOTE: Always use "TORX" socket wrench E10 when removing the rear seat.

REMOVE NO. 1 REAR SEAT LEG COVER
1. Disengage the 4 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.
  
  Fig 1: Identifying No. 1 Rear Seat Leg Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEAT ASSEMBLY
1. Using "TORX" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.
  
  Fig 2: Locating Rear Seat Cushion Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using "TORX" socket wrench E10, remove the 4 bolts and the rear seat.