LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Lower Instrument Panel >> Removal

Lower Instrument Panel: Removal

  1. TABLE OF BOLT, SCREW AND NUT 

    HINT:

    All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabet codes in the table below.

    Fig 1: Bolt, Screw And Nut Specification Table
    G05391423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable to prevent the airbag working.
  3. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  4. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  5. REMOVE COWL SIDE TRIM BOARD RH  (See REMOVAL )
  6. REMOVE COWL SIDE TRIM BOARD LH  (See REMOVAL )
  7. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See REMOVAL )
  8. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL )
  9. REMOVE FRONT PILLAR GARNISH RH  (See REMOVAL )
  10. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
  11. REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY  (See REMOVAL  )
  12. REMOVE INSTRUMENT CLUSTER FINISH LOWER PANEL  (See REMOVAL  )
  13. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  (See REMOVAL  )
  14. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  15. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL  )
  16. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL  )
  17. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) 
    1. Turn the shift lever knob counterclockwise and remove the shift lever knob.
      Fig 2: Turning Shift Lever Knob Counterclockwise
      G05391424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE INSTRUMENT CLUSTER FINISH CENTER LOWER PANEL 
    1. Disengage the 2 clips, 4 claws and remove the instrument cluster finish center lower panel.
    2. Disconnect the hazard warning switch connector.
      Fig 3: Identifying Instrument Cluster Finish Center Lower Panel Clips And Claws
      G05391425Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE FRONT NO. 2 CONSOLE BOX INSERT 
    1. Disengage the 3 claws and guide and remove the front console box insert.
      Fig 4: Identifying Front No. 2 Console Box Insert Claws
      G05391426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE FRONT NO. 1 CONSOLE BOX INSERT 
    1. Disengage the 3 claws and guide and remove the front console box insert.
      Fig 5: Identifying Front No. 1 Console Box Insert Claws
      G05391427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL (for Manual Transaxle) 
    1. Remove the 2 < A > screws.
      Fig 6: Locating Instrument Panel Finish Lower Panel Screws
      G05391428Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 6 clips and remove the instrument panel finish lower panel.
      Fig 7: Identifying Instrument Panel Finish Lower Panel Clips
      G05391429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  22. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL (for Automatic Transaxle) 
    1. Remove the 4 < A > screws.
      Fig 8: Locating Instrument Panel Finish Lower Panel Screws
      G05391430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 6 clips and remove the instrument panel finish lower panel.
    Fig 9: Identifying Instrument Panel Finish Lower Panel Clips
    G05391431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  23. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  24. REMOVE SHIFT LEVER ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  25. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  26. REMOVE SHIFT LEVER ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  27. REMOVE AIR CONDITIONING PANEL ASSEMBLY  (See REMOVAL )
  28. DISCONNECT NO. 2 HEATER CONTROL CABLE SUB-ASSEMBLY  (See REMOVAL )
  29. DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY  (See REMOVAL )
  30. REMOVE NO. 1 SWITCH HOLE BASE 
    1. Disengage the 2 clips, 3 claws and remove the switch hole base
    2. Disconnect the 2 connectors.
      Fig 10: Identifying No. 1 Switch Hole Base Clips And Claws
      G05391432Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  31. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL SUB-ASSEMBLY 
    1. Disengage the 2 clips and the 7 claws and remove the instrument panel finish lower panel.
    2. Disconnect the each connectors.
      Fig 11: Identifying Instrument Panel Finish Lower Panel Clips And Claws
      G05391433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  32. REMOVE INSTRUMENT PANEL SUB REINFORCEMENT 
    1. Remove the 2 < D > bolts and remove the instrument panel sub reinforcement.
      Fig 12: Locating Instrument Panel Sub Reinforcement Bolts
      G05391434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  33. REMOVE RADIO BRACKET 
    1. Remove the 2 < G > bolt and remove the No. 1 radio bracket.
    2. Remove the 2 < G > bolt and remove the No. 2 radio bracket.
      Fig 13: Locating Radio Bracket Bolts
      G05391435Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  34. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL SEAL 
    1. Disengage the 4 claws and remove the instrument cluster finish panel seal.
      Fig 14: Identifying Instrument Cluster Finish Panel Seal Claws
      G05391436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  35. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. Disengage the 3 claws and separate the hood lock control lever.
      Fig 15: Identifying Hood Lock Control Lever Claws
      G05391437Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  36. SEPARATE ANTENNA CORD SUB-ASSEMBLY 
    1. Disconnect the 2 clamps and separate the antenna cord.
      Fig 16: Identifying Antenna Cord Clamps
      G05391438Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  37. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 
    1. Disengage the 2 claws and disconnect the DLC3 connector.
      Fig 17: Identifying DLC3 Connector Claws
      G05391439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the front passenger seat belt warning light connector.
    3. Disconnect the 2 clamps.
    4. Remove the < A > screw, 10 < C > screws, 2 < E > bolts, < F > screw and remove the lower instrument panel.
      Fig 18: Identifying & Disconnecting 2 Lower Instrument Panel Screws And Clamps
      G05391440Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  38. REMOVE FRONT PASSENGER SEAT BELT WARNING LIGHT 
    1. Disengage the 2 claws and remove the front passenger seat belt warning light.
      Fig 19: Identifying Front Passenger Seat Belt Warning Light Claws
      G05391441Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  39. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY 
    1. Disengage the claw and remove the glove compartment door stopper.
      Fig 20: Identifying Glove Compartment Door Stopper Claw
      G05391442Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  40. REMOVE NO. 2 INSTRUMENT PANEL BOX 
    1. Remove the 8 < A > screws and the instrument panel box.
      Fig 21: Identifying No. 2 Instrument Panel Box Screws
      G05391443Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals