LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (E351 Manual Transaxle) >> Shift Lever Assembly >> Removal

Shift Lever Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE INSTRUMENT CLUSTER FINISH CENTER LOWER PANEL  (See REMOVAL )
  3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT  (See REMOVAL )
  4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL  (See REMOVAL )
  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Disconnect the control shift cable from the shift lever assembly.
    2. Disconnect the control select cable from the shift lever assembly.
      Fig 1: Locating Select Cable And Shift Cable
      G05388730Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Turn the adjust nut 180° clockwise. While holding the adjust nut, separate the control cable assembly.
      Fig 2: Identifying Adjusting Nut
      G05388731Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE SHIFT LEVER ASSEMBLY 
    1. Remove the 4 nuts and the shift lever assembly.
      Fig 3: Locating Shift Lever Assembly And Nut
      G05388732Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals