LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (48 - Steering (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 489819 Removing And Installing Hydraulic Pump - V8 >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Pentosin in engine compartment

Before installing a new reservoir, the steering system must be flushed following repairs.

>489729 FLUSHING THE STEERING SYSTEM 

Replace the reservoir if necessary. This instruction applies to all reservoirs with or without PDCC.

>489719 REMOVING AND INSTALLING RESERVOIR 

  1. Bleed the steering system and check the fluid level.

    >4890IN TEST AND ASSEMBLY WORK ON POWER STEERING 

  2. Install air cleaner housing.

    > 242519 Removing and installing air cleaner housing - section on "INSTALLING "

  3. Fit the air box for the throttle housing (Y-shaped pipe).

    > 243519 Removing and installing air box for throttle housing (Y-shaped pipe) - section on "INSTALLING "

  4. Fit wheel housing liner.

    > 505619 Removing and installing front wheel housing liner - section on "INSTALLING "

  5. Fit engine guard.

    > 108019 Removing and installing engine guard - section on "INSTALLING "

  6. Fit the left front wheel.

    > 440519 Removing and installing wheel - section on "INSTALLING "