LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (47 - Brakes - Hydraulic Brake System, Regulator) >> WM 471519 Removing And Installing Brake Master Cylinder (HBZ) (All Models) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit the right and the rear covers → Installing front trim (engine compartment) and the cowl panel → Installing cowl panel cover .
  2. Install both wiper arms → Installing wiper arms .
  3. Bleed the vehicle → Bleeding The Brake System  .

    After the bleeding operation, do not top up the brake fluid level above MAX 

    Fig 1: Identifying Brake Fluid Reservoir Marking
    G09419715Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Calibrate the pressure sensor with the Porsche System Tester.
scientia non olet · About LEMON Manuals