LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (97 - Cables -- CARRERA (997)) >> WM 975719 Removing And Installing Wire Harness For Seat Surface (Front Seat) (All Models) >> Preliminary work

Preliminary work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. → Disconnecting And Connecting The Battery
  2. Remove the front seat. → Removing Front Seat - section on "Removing"
  3. Mount the front seat on the assembly fixture. → Mounting Front Seat On Assembly Fixture
  4. Remove control unit for memory seat adjustment. → Removing Control Unit For Memory Seat Adjustment - section on "Removing"
  5. Remove suction fan for seat surface. → Removing Suction Fan For Seat Surface - section on "Removing"

    Information 

    Only required for wire harness for suction fan and seat heating.

  6. Remove covering for middle backrest. → Removing Cover For Front Middle Backrest - section on "Removing"

    Information 

    Only required for wire harness for suction fan and seat heating.

  7. Loosen covering for front backrest on the left side until you can reach the backrest cover. → Removing Cover For Front Backrest - section on "Removing"

    Information 

    Only required for wire harness for suction fan and seat heating.

  8. Remove backrest cover on the left side at the inside and outside. → Removing Cover For Backrest - section on "Removing"
scientia non olet · About LEMON Manuals