Mounting Front Seat On Assembly Fixture

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit seat mounting -1- on the assembly stands -2- .

Fig 1: Fitting Seat Mounting
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Adjust the seat mounting.

Fig 2: Adjusting Seat Mounting
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Loosen locking lever -1- (-arrow A- ).
2. 2.2. Adjust seat mounting -2- to the relevant width (-marking B- ) of the seat frame -arrow B- .
3. 2.3. Tighten locking lever -1- .
4. 2.4. Loosen fastening screw -1- and slide locking wedge -2- as far as the outer edge of the seat mounting -3- (-arrow A- ).
  
  Fig 3: Adjusting Locks
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. 2.5. Tighten fastening screw -1- .
6. 2.6. Slide locking lever -4- as far as the outer edge of the seat mounting -3- (-arrow B- ).
Fit front seat.

Fig 4: Fitting Front Seat
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Position the front seat -1- on the seat mounting -2- .
2. 3.2. Slide the seat frame as far as it will go into the locking wedge -3- (-arrow A- ).
3. 3.3. Slide locking lever -4- into the seat frame -arrow B- and lock it -arrow C- .
Information

The preload on the locking lever can be increased or reduced by turning the adjusting screw -5- .