LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (97 - Cables -- CARRERA (997)) >> WM 975719 Removing And Installing Wire Harness For Electrically Adjustable Seat (All Models) >> Installing Wire Harness For Electrically Adjustable Seat

Installing Wire Harness For Electrically Adjustable Seat

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Observe connector assignment!

Connect blue  connector to the motor for fore-and-aft adjustment.

Connect white  connector to the motor for front vertical adjustment.

Connect yellow  connector to the motor for rear vertical adjustment.

Connector overview for wire harness for electrically adjustable seat

Fig 1: Overview Of Connector Wire Harness For Electrically Adjustable Seat
G09831399Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Wire harness for control unit for memory seat adjustment - seat adjustment motors
  2. Wire harness for seat adjustment switch - control unit for memory seat adjustment
  1. Connector (grey) for control unit for memory seat adjustment (with memory only)
  2. Connector for seat adjustment motor
  3. Connector for motor for rear vertical adjustment
  4. Connector for motor for front vertical adjustment
  5. Connector (black) for control unit for memory seat adjustment (with memory only)
  6. Plug connections for seat adjustment switch
  7. Tie-wraps
  1. Route wire harness -B-  and secure with new tie-wraps -7-  .
  2. Push on connector -6-  on seat adjustment switch until it engages firmly. → Installing Control Module Trim Panel - section on "Installing"
  3. Attach connector -5-  to control unit for memory seat adjustment until it engages firmly. → Installing Control Unit For Memory Seat Adjustment - section on "Installing"
  4. Route the wire harness -A-  .
  5. Attach connector -4-  (white  ) to motor for front vertical adjustment until it engages firmly. → Installing Motor For Front Vertical Adjustment - section on "Installing"
  6. Attach connector -3-  (yellow  ) to motor for rear vertical adjustment until it engages firmly. → Installing Motor For Rear Vertical Adjustment - section on "Installing"
  7. Attach connector -2-  (blue  ) to motor for seat adjustment until it engages firmly. → Installing Motor For Seat Adjustment - section on "Installing"
  8. Attach connector -1-  to control unit for memory seat adjustment until it engages firmly. → Installing Control Unit For Memory Seat Adjustment - section on "Installing"
scientia non olet · About LEMON Manuals