Installing Motor For Rear Vertical Adjustment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert the drive shaft -1- into the gear mount -2- by twisting slightly.

Fig 1: Installing Drive Shaft
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push motor for rear vertical adjustment -3- onto the drive shaft by twisting slightly and secure with the two fastening screws -2- . → Tightening torque: 7 Nm (5 ftlb.)

Fig 2: Installing Motor For Rear Vertical Adjustment
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Attach connector -1- to motor for rear vertical adjustment -3- until it engages firmly.