LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (97 - Cables -- CARRERA (997)) >> WM 972519 Removing And Installing Rear Wire Harness (All Models) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Only for vehicles with tire pressure monitoring

  1. Install rear wheel housing liner. → Installing Rear Wheel Housing Liner - section on "Installing"
  2. Install rear underbody cover. → Installing Cover For Rear Underbody - section on "Installing"
  3. Install reservoir. → Installing Coolant Reservoir - section on "Installing"
  4. Install air cleaner housing. → Installing Air Cleaner Housing - section on "Installing"
  5. Install rear spoiler. → Installing Rear Spoiler - section on "Installing"
  6. Install rear light at left and right. → Installing Tail Light - section on "Installing"
  7. Install additional brake light. → Installing Auxiliary Brake Light - section on "Installing"

    Information 

    Only in the cabrio.

  8. Install roll-over bar. → Installing Roll-Over Bar Module - section on "Installing"

    Information 

    Only in the cabrio.

  9. Install frame for roll-over protection system. → Installing Frame For Roll-Over Protection System - section on "Installing"
  10. Install relay carrier. → Installing Relay Carrier 1  - section on "Installing" 
  11. Install trim panel for seat well. → Installing Trim Panel For Seat Well - section on "Installing"
  12. Install trim panel for rear wall → Installing Trim Panel For Rear Wall - section on "Installing"

    Information 

    Only in the coupe.

  13. Install C-pillar trim panel. → Installing C-Pillar Trim - section on "Installing"
  14. Install rear side trim panel at left and right. → Installing Rear Side Trim Panel - section on "Installing"
  15. Install left and right scuff plate. → Installing Inner Door Sill Trim - section on "Installing"
  16. Install front seat at left and right. → Installing Front Seat - section on "Installing"
  17. Carry out work instructions after disconnecting the battery. → Disconnecting And Connecting The Battery
scientia non olet · About LEMON Manuals