Section 4 (Convertible Top, Hardtop Diagnosis - 911 CARRERA (996))

• System B 3.2
  • General information
    • Diagnosis
    • Convertible-top control
  • System description
    • Notes
    • Overview of convertible-top components
  • Tools
    • Notes
    • Test adapter mounting instructions
  • Connector assignment, control module
  • Fault memory - up to model year 2002
    • Overview of possible faults (diagnostic trouble codes) - up to model year 2002
    • Test point 1
      • Fault code 01
      • Possible causes, elimination, notes
    • Test point 2
      • Fault code 02
      • Possible causes, elimination, notes
    • Test point 3
      • Fault code 03
      • Possible causes, elimination, notes
    • Test point 4
      • Fault code 04
      • Possible causes, elimination, notes
    • Test point 5
      • Fault code 05
      • Possible causes, elimination
    • Test point 6
      • Fault code 06
      • Possible causes, elimination
    • Test point 7
      • Fault code 07
      • Possible causes, elimination
  • Nominal values
    • Notes
    • Pot. 1, convertible top
    • Voltage measurement of convertible-top potentiometer
    • Pot. 2, convertible-top compartment lid
    • Voltage measurement of convertible-top compartment potentiometer
  • Calibrating convertible top
    • Notes
    • Information:
• Introduction - 911 Carrera (996) as of model year 2003
  • Notes
  • General instructions/safety instructions
  • General information on the fault memory
  • Diagnostic conditions
  • Possible causes of fault
  • Diagnosis/troubleshooting
    • Notes
    • Fault status
    • Counter
    • Basic conditions
• Tools
  • Notes
  • Porsche System Tester II 9588
  • Commercially available digital multimeter
  • 88-pin test adapter cable 9616
  • Pin template 9636/1
  • 45-pin test adapter 9636
  • Measurement tool set 9684
• Component arrangement
• Connector assignment
• Control unit function
  • Requirements
  • Replace control module
  • Coding
  • Calibration
  • Reset actuation counter 2
  • Reset warning light
• Fault overview
• Fault code 1
  • Switch position implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Affected pins
    • Diagnosis/troubleshooting
• Fault code 2
  • Switch short circuit to ground
    • Notes
    • Diagnostic conditions
    • Possible cause of fault
    • Affected pins
    • Diagnosis/troubleshooting
• Fault code 3
  • Convertible top pot. fault
    • Notes
    • Diagnostic conditions
    • Possible cause of fault
    • Affected pins
    • Diagnosis/troubleshooting
• Fault code 4
  • Convertible-top compartment lid pot. fault
    • Notes
    • Diagnostic conditions
    • Possible cause of fault
    • Affected pins
    • Diagnosis/troubleshooting
• Fault code 5
  • Timeout error
    • Notes
    • Diagnostic conditions
    • Possible cause of fault
    • Diagnosis/troubleshooting
• Fault code 6
  • Calibration required
    • Diagnostic conditions
    • Possible cause of fault
    • Diagnosis/troubleshooting
• Fault code 7
  • Supply voltage
    • Notes
    • Diagnostic conditions
    • Possible cause of fault
    • Affected pins
    • Diagnosis/troubleshooting