Rear Side Door Window Reveal Molding Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Reveal Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Place the window in the full up position. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement . Remove the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement . Remove the rear door window garnish molding. Refer to Back Body Opening Garnish Molding Replacement . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement . Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement . Remove the rear door window. Refer to Rear Side Door Window Replacement . Remove the rear door stationary window division channel. Refer to Rear Side Door Stationary Window and Front Channel Replacement .
1	Rear Door Window Reveal Molding Screw (Qty: 7) CAUTION: Refer to Fastener Caution . Tighten 1.3 N.m (12 lb in)
2	Rear Door Window Reveal Molding Use a plastic flat-bladed tool to release the reveal molding retainers from the front of the door window frame. Pull the reveal molding from the window frame.

Callout

Component Name

Preliminary Procedures

Place the window in the full up position.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Remove the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement .
Remove the rear door window garnish molding. Refer to Back Body Opening Garnish Molding Replacement .
Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement .
Remove the rear door window. Refer to Rear Side Door Window Replacement .
Remove the rear door stationary window division channel. Refer to Rear Side Door Stationary Window and Front Channel Replacement .

Rear Door Window Reveal Molding Screw (Qty: 7)

CAUTION:

Refer to Fastener Caution .

Tighten
1.3 N.m (12 lb in)

Rear Door Window Reveal Molding

Use a plastic flat-bladed tool to release the reveal molding retainers from the front of the door window frame.
Pull the reveal molding from the window frame.