Rear Side Door Stationary Window and Front Channel Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Stationary Window & Front Channel

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Place the window in the full up position. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement . Remove the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement . Remove the rear door window garnish molding. Refer to Back Body Opening Garnish Molding Replacement . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement . Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement . Remove the rear door window. Refer to Rear Side Door Window Replacement .
1	Rear Door Stationary Window Division Post Bolt CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Rear Door Stationary Window Pull the stationary window sealing strip from the door frame. Tip the stationary window forward to remove it from the door.

Callout

Component Name

Preliminary Procedures

Place the window in the full up position.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Remove the rear door inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement .
Remove the rear door window garnish molding. Refer to Back Body Opening Garnish Molding Replacement .
Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement .
Remove the rear door window. Refer to Rear Side Door Window Replacement .

Rear Door Stationary Window Division Post Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
9 N.m (80 lb in)

Rear Door Stationary Window

Pull the stationary window sealing strip from the door frame.
Tip the stationary window forward to remove it from the door.