LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6T70/6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

  1. Set the parking brake.
  2. Ensure that the shift control range select lever is in the park (P) position.
    3. Fig 1: Identifying Range Selector Cable & Shift Control Cable
    GM1949985Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the shift control cable (1) from the transmission range selector lever.
  4. Depress the range selector cable retainer clip tabs (2) and remove the range selector cable from the range selector cable bracket.
  5. Remove the shift control lever knob. Refer to Transmission Control Lever Knob Replacement .
  6. Remove the center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
  7. Remove the console trim plate. Refer to Console Trim Plate Replacement .
  8. Remove the right side console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
    9. Fig 2: Identifying Shift Control Cable
    GM1949984Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the shift control cable (1) from the shift control range select lever pin.
  10. Depress the shift control cable retainer clip tabs and remove the cable (2) from the shift control.
    11. Fig 3: View Of Selector Cable Grommet
    GM944396Courtesy of GENERAL MOTORS CORP.
  11. Remove the shift control cable grommet from the cowl.
  12. Note the shift control cable routing and remove the shift control cable from the vehicle.
scientia non olet · About LEMON Manuals