Special Tools Required

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Valve spring compressor attachment 07757-PJ1010A

Identify the valves and valve springs as they are removed so that each item can be reinstalled in its original position.

Remove the cylinder head (see CYLINDER HEAD REMOVAL ).
Remove the rocker arm assembly (see ROCKER ARM ASSEMBLY REMOVAL )
Remove the camshaft (see CAMSHAFT REMOVAL )
Using an appropriate-sized socket (A) and plastic mallet (B), lightly tap the spring retainer to loosen the valve cotters.

Fig 1: Tapping Spring Retainer To Loosening Valve Cotters Using Socket & Plastic Mallet
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the valve spring compressor attachment and the valve spring compressor. Compress the valve spring and remove the valve cotters.

Fig 2: Identifying Valve Spring Compressor & Attachment
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the valve spring compressor and the valve spring compressor attachment, then remove the spring retainer, the valve spring, and the valve.
Install the valve guide seal remover.

Fig 3: Identifying Valve Guide Seal Remover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the valve seal.

Fig 4: Identifying Valve Seal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the valve spring seat.