Rocker Arm Assembly Removal

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cylinder head cover (see CYLINDER HEAD COVER REMOVAL ).
Loosen the rocker arm adjusting screws (A).

Fig 1: Identifying Rocker Arm Adjusting Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Unscrew the rocker shaft mounting bolts two turns at a time in sequence shown below.

Fig 2: Identifying Rocker Shaft Mounting Bolts Loosening Sequence
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the rocker shaft mounting bolts, then remove the rocker arm assembly.

Fig 3: Identifying Rocker Arm Assembly With Rocker Shaft Mounting Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.