LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Disassembly And Assembly >> Transfer Case >> Disassembly

Transfer Case: Disassembly

  1. Remove adapter case. Refer to "DISASSEMBLY ".
  2. Remove gear ring assembly. Refer to "DISASSEMBLY ".
  3. Remove drive pinion assembly. Refer to "DISASSEMBLY ".
  4. Remove transfer case oil seal with a suitable tool.
    CAUTION: Never damage transfer case.
    Fig 1: Identifying Transfer Case Oil Seal
    G04921296Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove the oil defense.
    Fig 2: Removing Oil Defense
    G05892811Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Using a brass rod, tap the gear ring bearing adjusting shim (transfer case side) evenly from the 2 cutouts on the transfer case to remove the gear ring bearing adjusting shim (transfer case side) and gear ring bearing outer race (transfer case side).
  7. Remove air breather hose from transfer case.
    CAUTION: Never damage air breather hose.
  8. Remove air breather tube from transfer case.
  9. Remove the filler plug from the transfer case, and then remove each gasket.
  10. Remove plug from transfer case.
Fig 3: Tapping Gear Ring Bearing Adjusting Shim
G04921298Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals