LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Transmission >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Disassembly And Assembly >> Adapter Case >> Disassembly

Adapter Case: Disassembly

  1. Remove adapter case mounting bolts (←).
    Fig 1: Identifying Adapter Case Mounting Bolts
    G04921287Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Lightly tap adapter case with a plastic hammer to remove adapter case.
    Fig 2: Tapping Adapter Case To Remove
    G04921288Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove O-ring from adapter case.
  4. Remove adapter case oil seal with a suitable tool.
    CAUTION: Be careful not to damage adapter case.
    Fig 3: Identifying Adapter Case Oil Seal
    G04921289Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Using a brass rod, tap the gear ring bearing adjusting shim at the cutout on the adapter case to remove the gear ring bearing adjusting shim (adapter case side) and gear ring bearing outer race (adapter case side).
    Fig 4: Tapping Gear Ring Bearing Adjusting Shim From Cutout On Adapter Case
    G04921290Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove the oil gutter (1).
    Fig 5: Identifying Oil Gutter
    G05892772Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove the drain plug.
scientia non olet · About LEMON Manuals