Section 5 (Manual Transaxle Overhaul)
WARNING: This page is about a different variant/trim than selected.
- General Specifications
- Service Specifications
- Adjusting Snap Rings And Spacers
- Fastener Tightening Specifications
- Sealants And Adhesives
- Lubricants
- Special Tools
- Transaxle
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Adjustment Before Assembly
- Assembly Service Points
- >> A << Reverse Idler Gear, Reverse Idler Thrust Washer And Reverse Idler Shaft Installation
- >> B << Gear Shift Fork Assembly No. 1 And Gear Shift Fork Shaft No. 1 Installation
- >> C << Reverse Shift Arm Bracket Assembly Installation
- >> D << Transaxle Case Assembly Installation
- >> E << 5TH Drive Gear Installation
- >> F << 5TH Drive Gear Mounting Lock Nut Installation
- >> G << Synchronizer Ring Assembly/Synchromesh Shifting Key Spring No. 3 (A)/Synchromesh Shifting Key Spring No. 3 (B) And Synchronizer Hub No. 3 Installation
- >> H << Shaft Snap Ring Installation
- >> I << Synchronizer Sleeve No. 3 Installation
- >> J << Transaxle Case Cover Sub Assembly Installation
- >> K << Oil Seal Installation
- >> L << Control Shift Retainer Gasket Installation
- >> M << Plug Installation
- Inspection
- Disassembly And Assembly
- Input Shaft
- Output Shaft
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly SERVICEPOINTS
- >> A << Tapered Roller Bearing Inner Race Installation
- >> B << Synchronizer Ring Set No. 1 (Synchronizer Outer Ring No. 1, Synchronizer Middle Ring No. 1, Synchronizer Inner Ring No. 1) Installation
- >> C << Reverse Gear And Synchronizer Hub No. 1 INSTALLTION
- >> D << Synchronizer Ring Set No. 2 (Synchronizer Outer Ring No. 2, Synchronizer Middle Ring No. 2, Synchronizer Inner Ring No. 2) And 2ND Gear Installation
- >> E << 3RD Drive Gear Installation
- >> F << 4TH Drive Gear Installation
- >> G << Tapered Roller Bearing Inner Race Installation
- Disassembly And Assembly
- Select Lever
- BELLCRANK
- Clutch Housing
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- >> A << Oil Seal Installation
- >> B << Oil Seal Installation
- >> C << Extension Housing Oil Baffle Installation
- >> D << Tapered Roller Bearing Outer Race Installation
- >> E << Output Shaft Cover Installation
- >> F << Tapered Roller Bearing Outer Race Installation
- >> G << Cylindrical Roller Bearing (Outer Race) Installation
- Disassembly And Assembly
- Transaxle Case
- Differential