Section 2 (Electronic Control (AWD) - With Diagnostics)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Service Precautions
- Service Specifications
- Sealant
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Precautions For Diagnosis
- Check Of Drive Mode Indicators (AWD/Lock)
- Diagnostic Function
- Freeze Frame Data Reference Table
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C1078: Tire with incorrect diameter equipped
- DTC C1456: Wiring harness or coupling coil overcurrent failure
- DTC C145A: Wiring harness and coupling coil short circuit failure
- DTC C145D: Wiring harness and coupling coil open circuit failure
- DTC C145F: Coupling Overload
- Code No. C1460: Mode SW performance
- DTC C2100: Abnormal battery voltage (Too low)
- DTC C2101: Abnormal battery voltage (Too high)
- DTC C211C: Abnormal IG1 power supply low voltage
- DTC C211D: Abnormal IG1 power supply high voltage
- DTC C211E: Abnormal power supply voltage (Too low)
- DTC C211F: Abnormal power supply voltage (Too high)
- DTC C2208: AWD-ECU internal error
- DTC U0001: Bus-off error
- DTC U0100: Engine CAN time-out
- DTC U0121: ASC CAN time-out
- DTC U0141: ETACS CAN time-out
- DTC U0401: Engine CAN data error
- DTC U0415: ASC CAN data error
- DTC U113C: Wheel speed sensor data error
- DTC U1415 Variant coding not implemented
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Scan Tool MB991958 Cannot Communicate with the Electronic Control AWD System
- Inspection Procedure 2: Shifting the Drive Mode Selector Does Not Change the Mode
- Inspection Procedure 3: The Tight Corner Braking Phenomenon* Appears with the Drive Mode Selector in the AWD ECO or AWD AUTO Position
- Inspection Procedure 4: No DTC Is Set Even When the AWD/LOCK Indicator Lights Flash
- Data List Reference Table
- Actuator Test Table
- Check At Ecu Terminals
- On-Vehicle Service
- AWD-Ecu
- Drive Mode Selector
- Electronic Control Coupling