Section 35 (Controller Area Network (Can) Diagnosis)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Special Tools
- Test Equipment
- Service Precautions
- Precautions On How To Repair The Can Bus Lines
- Explanation About The Scan Tool (M.U.T.-III) Can Bus Diagnostics
- Diagnosis
- Can Bus Diagnostics Table
- Can-Related Connector Position
- Can Bus Diagnostics
- Diagnostic Item 1: Communication with no ECUs is possible (CAN-C)
- Diagnostic Item 2: Diagnose shorts in the power supply to CAN-C
- Diagnostic Item 3: Diagnose shorts in the ground to CAN-C
- Diagnostic Item 4: Diagnose shorts between CAN_H and L lines (CAN-C)
- Diagnostic Item 5: Communication with no ECUs is possible (CAN-C-Mid)
- Diagnostic Item 6: Diagnose shorts in the power supply to CAN-C-Mid
- Diagnostic Item 7: Diagnose shorts in the ground to CAN-C-Mid
- Diagnostic Item 8: Diagnose shorts between CAN_H and L lines (CAN-C-Mid)
- Diagnostic Item 9: Diagnose when the scan tool cannot receive the data sent by ETACS-ECU
- Diagnostic Item 10: Diagnose when the scan tool cannot receive the data sent by SRS-ECU
- Diagnostic Item 11: Diagnose when the scan tool cannot receive the data sent by steering wheel sensor
- Diagnostic Item 12: Diagnose when the scan tool cannot receive the data sent by AWD-ECU < AWD >
- Diagnostic Item 13: Diagnose when the scan tool cannot receive the data sent by LDW-ECU. < vehicles with LDW >
- Diagnostic Item 14: Diagnose when the scan tool cannot receive the data sent by occupant classification-ECU
- Diagnostic Item 15: Diagnose the lines between the joint connectors (CAN3 and CAN1)
- Diagnostic Item 16: Diagnose when the scan tool cannot receive the data sent by ASC-ECU
- Diagnostic Item 17: Diagnose when the scan tool cannot receive the data sent by EPS-ECU
- Diagnostic Item 18: Diagnose when the scan tool cannot receive the data sent by transaxle control module (TCM)
- Diagnostic Item 19: Diagnose the lines between the joint connectors (CAN1 and CAN2)
- Diagnostic Item 20: Diagnose when the scan tool cannot receive the data sent by ACC/FCM-ECU. < vehicles with ACC >
- Diagnostic Item 21: Diagnose when the scan tool cannot receive the data sent by engine control module
- Diagnostic Item 22: Diagnose when the scan tool cannot receive the data sent by KOS-ECU. < Vehicles with KOS >
- Diagnostic Item 23: Diagnose when the scan tool cannot receive the data sent by OSS-ECU. < Vehicles with OSS >
- Diagnostic Item 24: Diagnose when the scan tool cannot receive the data sent by CAN box unit < vehicles with MMCS >
- Diagnostic Item 25: Diagnose when the scan tool cannot receive the data sent by radio and CD player < vehicles with radio and CD player >
- Diagnostic Item 26: Diagnose when the scan tool cannot receive the data sent by A/C-ECU
- Diagnostic Item 27: Diagnose when the scan tool cannot receive the data sent by power liftgate control unit < vehicles with power liftgate >
- Diagnostic Item 28: Diagnose when the scan tool cannot receive the data sent by combination meter
- Can Communication-Related DTC (U-Code) Table