Section 99 (MULTIPORT Fuel Injection (MFI) (1 Of 6) - Lancer Evolution)
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- General Specifications
- Service Specifications
- Sealant And Adhesive
- Special Tool
- MULTIPORT Fuel Injection (MFI) Diagnosis
- Troubleshooting Strategy
- Diagnostic Function
- Notes
- Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp)
- Items Indicated by the Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp)
- How To Connect The Scan Tool (M.U.T.-III)
- How To Read And Erase Diagnostic Trouble Codes
- How To Read Data List
- How To Perform Actuator Test
- How To Diagnose The Can Bus Lines
- PROVISIONAL DTCs [OBD-II Test Mode - Results (Mode 7)]
- Mode 6 Reference Table
- Diagnostic By Diagnostic Test Mode II (Increased Sensitivity)
- On-Board Diagnostics
- OBD-II Drive Cycle
- Drive Cycle Pattern List
- Pattern 1
- Pattern 2
- Pattern 3
- Pattern 4
- Pattern 5
- Pattern 6
- Pattern 7
- Pattern 8
- Pattern 9
- Pattern 10
- Pattern 11
- Pattern 12
- Pattern 13
- Pattern 14
- Pattern 15
- Pattern 16
- Pattern 17
- Pattern 18
- Pattern 19
- Pattern 20
- Pattern 21
- Pattern 22
- Pattern 23
- System Readiness Test Status
- Fail-Safe Function Reference Table
- Diagnostic Trouble Code Chart
- Symptom Chart