Service Specifications
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
SERVICE SPECIFICATIONS
| ITEMS | STANDARD VALUE | |
|---|---|---|
| Fuel pressure kPa (psi) | Vacuum hose disconnected | 310 - 345 (45 - 50) at curb idle |
| Vacuum hose connected | Approximately 260 (38) at curb idle | |
| Intake air temperature sensor 1 resistance kΩ | -20°C (-4°F) | 13 - 17 |
| 0°C (32°F) | 5.4 - 6.6 | |
| 20°C (68°F) | 2.3 - 3.0 | |
| 40°C (104°F) | 1.0 - 1.5 | |
| 60°C (140°F) | 0.56 - 0.76 | |
| 80°C (176°F) | 0.31 - 0.43 | |
| Intake air temperature sensor 2 resistance kΩ | -20°C (-4°F) | 13 - 18 |
| 0°C (32°F) | 5.1 - 6.9 | |
| 20°C (68°F) | 2.0 - 3.0 | |
| 40°C (104°F) | 0.9 - 1.5 | |
| 60°C (140°F) | 0.40 - 0.78 | |
| 80°C (176°F) | 0.23 - 0.42 | |
| Engine coolant temperature sensor resistance kΩ | -20°C (-4°F) | 14 - 17 |
| 0°C (32°F) | 5.1 - 6.5 | |
| 20°C (68°F) | 2.1 - 2.7 | |
| 40°C (104°F) | 0.9 - 1.3 | |
| 60°C (140°F) | 0.48 - 0.68 | |
| 80°C (176°F) | 0.26 - 0.36 | |
| Heated oxygen sensor output voltage V | 0.6 - 1.0 | |
| Heated oxygen sensor heater resistance Ω | Front | 4.5 - 8.0 |
| Rear | 4.5 - 8.0 | |
| Injector coil resistance Ω | 10.5 - 13.5 [at 20°C (68°F)] | |
| Throttle actuator control motor coil resistance Ω | 0.3 - 80 [at 20°C (68°F)] | |
| Fuel pump circuit resistor resistance Ω | 0.45 - 0.65 [at 20°C (68°F)] | |
| Intake engine oil control valve coil resistance Ω | 6.9 - 7.9 [at 20°C (68°F)] | |
| Exhaust engine oil control valve coil resistance Ω | 6.9 - 7.9 [at 20°C (68°F)] | |