Special Tool
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL DESCRIPTION CHART
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
MB991958
M.U.T.-III sub assembly
|
MB991824-KIT
NOTE:
G: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
|
CAUTION:
For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
|
|
| MB992110 Power plant ECU check harness |
- |
|
|
| MB991709 Test harness |
MB991709-01 | Inspection using an oscilloscope | |
| MB991658 Test harness |
Tool not available |
|
|
| MB992049 | MB992049-01 | Measurement of fuel pressure | |
| MB992001 | Hose adaptor | Measurement of fuel pressure | |
| MB991981 Fuel pressure gauge set |
Tool not available | Measurement of fuel pressure | |
| MB992076 | Injector test set | Measurement of fuel pressure | |
| MB992042 Engine coolant temperature sensor wrench |
- | Removal and installation of the engine coolant temperature sensor | |
| MB992106 O-ring installer |
- | Installation of O-ring on injector injection nozzle side |