Install backrest frame

• Correctly position the rear seat backrest (5)  .

  If necessary, feed in relative cables.

  NOTE: Perform the steps on the right and left side.
• Tighten the screws (4)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Seat frame to backrest frame
  Screw Replace screw.	tightening torque	38 Nm

• F56/57: 

  Correctly attach cable linkage (1)  in holders (2)  and (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE BACKREST COVERING WITH THE CUSHION .
• Refer to INSTALLING SIDE AIRBAG ON FRONT SEAT .
• Refer to INSTALLING THE TRIM AT THE BOTTOM OF THE APERTURE .
• Refer to INSTALLING THE REAR PANEL ON THE FRONT SEAT BACKREST .
• Refer to REMOVING THE SEAT COVER WITH CUSHION .
• Refer to INSTALLING THE THIGH SUPPORT ON THE FRONT SEAT .
• Refer to INSTALLING THE OUTER COVER ON THE FRONT SEAT .
• Refer to INSTALLING THE LEVER FOR SEAT HEIGHT ADJUSTMENT .
• Refer to INSTALLING THE STEERING LEVER FOR BACKREST ADJUSTMENT .
• Refer to INSTALLING THE COVER FOR BACKREST ADJUSTMENT .
• Refer to INSTALLING INNER COVER .
• Refer to INSTALLING FRONT SEAT .
• Refer to INSTALLING THE FRONT STRAP FITTING .