Removing and installing/replacing holder with rubber mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove front UNDERBODY PROTECTION .
Remove THRUST FIELD .

Removal:

IMPORTANT: Support engine with lifter.

Undo bolts (1) and remove holder (2) with rubber mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install holder (1) with rubber mount.

Tighten down screws (2).

Tightening torque 22 11 4AZ .

Tighten screw (3).

Tightening torque 22 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install THRUST FIELD .
Install front UNDERBODY PROTECTION .