Removing and installing/replacing thrust field (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove front UNDERBODY PROTECTION .

Removal:

Loosen screws (1).

Loosen screws (2).

Remove underbody protection (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position underbody protection (3).

Replace screws (2).

Parts : screw

Tightening torque 31 11 4AZ .

Tighten down screws (1).

Tightening torque 31 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install front UNDERBODY PROTECTION .