Replacing boost pressure sensor (upstream of throttle valve) (Cooper)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic damage (ESD protection).
Preliminary work needed:
- Remove THROTTLE BODY .
Removal:
Remove screw (1).
Remove boost pressure sensor (2).
Preparation for installation:
Check sealing ring of boost pressure sensor and replace in event of damage or loss.
Part : Sealing ring
Prior to installation, apply a thin coat of anti-friction agent to sealing ring of charge-tire pressure sensor.
Installation :
Install boost pressure sensor (2).
Tighten down screw.
Tightening torque 13 62 4AZ .
Required follow-up work :
- Install THROTTLE BODY .