REP-TAT-P-5218-01 Remove lumbar support
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the BATTERY GROUND LEAD from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: NOTE airbag safety regulations!
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: NOTE airbag safety regulations!
Preliminary work
- Remove the front STRAP FITTING
- Remove FRONT SEAT
- Remove INNER COVER
- Remove the COVER for backrest adjustment
- Remove the STEERING LEVER for backrest adjustment
- Remove the LEVER for seat height adjustment
- Remove the OUTER COVER on the front seat
- Remove the REAR PANEL from the front seat backrest
- Remove the TRIM at the bottom of the aperture
- Remove/replace SIDE AIRBAG
- Remove the BACKREST SEAT COVER WITH CUSHION
- Detach lumbar support (3) from the holders (1) and backrest frame (2).
- Cover working area and drill out blind rivet (1).
- Remove adjuster (2) and take it out with the Bowden cable from the backrest frame.