REP-TAT-P-5218-01 Removing backrest frame
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the BATTERY GROUND LEAD from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: NOTE airbag safety regulations!
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: NOTE airbag safety regulations!
Preliminary work
- Remove the front STRAP FITTING
- Remove FRONT SEAT
- Remove INNER COVER
- Remove the COVER for backrest adjustment
- Remove the STEERING LEVER for backrest adjustment
- Remove the LEVER for seat height adjustment
- Remove the OUTER COVER on the front seat
- Remove the REAR PANEL from the front seat backrest
- Remove the TRIM at the bottom of the aperture
- Remove/replace SIDE AIRBAG
- Remove BACKREST SEAT COVER WITH CUSHION
- Shift the rear seat backrest into an upright position.NOTE: Perform the steps on the right and left side.
- Loosen screws (4).
- Completely remove the backrest frame (5) to the top.
If necessary, feed out the relative cable and set aside rear seat backrest.