31 11 001 Replacing front axle support
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace self-tapping screws for mounting following components on front axle/engine support.
- Steering box
- Holder, wishbone/retaining bracket, anti-roll bar
- Bumper holder
- Holder, ride height sensor
- Front axle support (if replacing engine supports)
Necessary preliminary tasks:
- Lower FRONT AXLE SUPPORT .
- Remove BOTH TRACK ROD ENDS FROM SWIVEL BEARING
- Remove BOTH WISHBONES FROM SWIVEL BEARING .
- Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .
Installation note:
Use previous front axle support as a template for modifying or replacing small parts.
Modify STABILIZER .
If necessary, modify RIDE HEIGHT SENSOR .
Modify BOTH WISHBONES .
Modify STEERING BOX .
Modify BOTH BUMPER HOLDERS .
After installation:
- Wheel alignment is only necessary after replacement and/or renewal of front axle support! See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT (WITHOUT VEHICLE LOAD) .