63 12 007 Removing and installing/replacing left or right headlight (halogen headlight)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Follow instructions for handling light bulbs (exterior lights
).
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION
).
Release screws (1). Tightening torque 63 12 1AZ .
Disconnect plug connection (2).
Version with headlight washer system:
- Pull headlight forwards slightly and detach hose connection (3) from high-pressure nozzle (4).
Remove headlight.
Installation:
- Adjust gap dimensions by means of adjusting screws (1).
- Adjust headlight .
Replacement:
- Modify halogen bulb for headlight
- Modify halogen bulb for high-beam headlight
- Modify bulb for direction indicator
- If necessary, modify high-pressure nozzle of headlight washer system. See 61 67 083 REMOVING AND INSTALLING / REPLACING LEFT OR RIGHT HIGH-PRESSURE NOZZLE OF HEADLIGHT WASHER SYSTEM .
- Modify adjusting screws