41 62 018 Adjusting left and right Splitdoor to fit

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not damage adjoining body parts.
Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

Refer to relevant service information in BODY, GENERAL .

Observe GAP DIMENSIONS .

The Splitdoor must be provided with all attachment parts for correct adjustment.

When the door is closed, the lock striker must not touch or scrape against the door lock. Look out for scratches.

Slacken lock striker, remove if necessary.

Necessary preliminary tasks:

Remove REAR LIGHT .
Remove TRIM ON SPLITDOOR .

Left Splitdoor:

Release screws and remove holder (2).

If necessary, release wiring harness (1) from body.

Installation:

Make sure wiring harness is correctly seated (watertightness).

Fig 1: Release Screws And Remove Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nuts until Splitdoor can still just be moved.

Tightening torque 41 62 2AZ

Adjust Splitdoor laterally (Y) and vertically (Z).

Fig 2: Adjusting Splitdoor Laterally (Y) And Vertically (Z)

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws until Splitdoor can still just be moved.

Tightening torque 41 62 3AZ

Adjust Splitdoor in longitudinal direction (X).

Fig 3: Adjusting Splitdoor In Longitudinal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Tighten all screws and nuts to specified torque.
Touch up unpainted surfaces in the appropriate color.
Adjust STRIKER .