Rear Axle - Service Information -- S Clubman (R55)

• Kinematic Diagnosis System And Environment
  • 1.1 Objective
• 1. Foreword
  • 1.2 Further development of the BMW Kinematic Diagnosis System
  • 1.3 Technical Data
  • 1.4 Scope of delivery
  • 1.5 Accessories required
  • 1.6 Accessories recommended
• 2. Measuring Options Using BMW Kinematic Diagnosis System
  • 2.1 Front axle
  • 2.2 Rear axle
  • 2.3 Other measuring options
• 3. System Description
  • 3.1 BMW Kinematic Diagnosis System 1, based on the Beissbarth ML4000
  • 3.2 Computer
  • 3.3 Graphical tablet
  • 3.4 Equipment cabinet
  • 3.5 Remote display
  • 3.6 Measuring sensors with CCD camera
  • 3.7 BMW Quick-acting clamp
  • 3.8 Rotating / sliding plates
  • 3.9 Sensor pins
  • 3.10 Spoiler adapter
  • 3.11 Quick-clamping units
  • 3.12 Retainers
• 4. Workstation
  • 4.1 Environment
  • 4.2 Preconditions for alignment
  • 4.3 Measuring tolerance
  • 4.4 Levelling the measuring station
• 5. Chassis-Related Terms
  • 5.1 Toe-differential angle
  • 5.2 Camber
  • 5.3 Toe-in
  • 5.4 Castor
  • 5.5 Geometrical drive axis / symmetrical axis
  • 5.6 Wheel displacement angle
  • 5.7 Kingpin offset
• 6. Wheel Suspension
  • Notes
  • 6.1 Rigid axle suspension
  • 6.2 Independent wheel suspension
• 7. Wheel Alignment / Procedure
  • 7.1 Measuring options
  • 7.2 Preparatory work
  • 7.3 Initial / final measurement
  • 7.4 Printing out the data
• 8. Special Features
  • 8.1 Free wheel alignment
  • 8.2 System settings
• 9. BMW Kinematic Diagnosis System Comparison (BOSCH - BEISSBARTH)
• 10. Control Modification (Menu)
  • 10.1 Remote control with display
  • 10.2 Brief operating instructions
  • 10.3 Display support
• 11. Updating Software/SETPOINT Data
  • Notes
  • 11.1 Requirements
  • 11.2 Procedure (Beissbarth)
  • 11.3 Procedure (Bosch)
• 12. Creating, Copying And Editing SETPOINT Data
  • 12.1 Copying
  • 12.2 Creating
  • 12.3 Editing
• 13. Special Functions
  • 13.1 Customer-specific printer report header
  • 13.2 Adjusting options
  • 13.3 Rotating plate test
  • 13.4 Viewing and deleting customer entries from database
• 14. Modifications Within Program
• 15. Faults
  • 15.1 Tyre faults
  • 15.2 Front axle faults
  • 15.3 Rear axle faults