10.3 Display support
- Measured values with a setpoint/actual comparison and tolerance bar (setpoint figures can be displayed with the "F" key)
- Steering graphics for steering routines
- Overview of measured values with current setpoint/actual comparison
- Rim run-out compensation
- With all other functions (e.g. customer input), the title illustration appears on the LCD display
NOTE:
If the data transmission from the remote control to the computer is interrupted, the remote control icon in the bottom right-hand corner of the screen changes color from green to red and the illustration on the LCD display is shown inversely - black turns to white, white to black. This change does not take place in the title illustration. Once the line-of-sight connection has been re-established, the remote control continues to operate from the point of interruption in the program. A continuous visual connection during alignment is therefore not necessary.
- The "Hour glass" icon in the LCD display means: "Please wait".
- The "Battery" icon in the top right-hand corner of the LCD display means that the battery reserve has been reached.
- To switch off the remote control: press the "F" key for 5 seconds, then return it to its charging unit or connect it to a charge cable. The title illustration will again appear as a charging check.
- If, during the measurement, the remote control has been placed back in the charging unit, it must be switched on again using the "ON" button.