Section 1182 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid))
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2009 Mercury Mountaineer, 2009 Mercury Milan, 2009 Mercury Mariner, 2009 Mercury Grand Marquis, and 2009 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Methods
- Diagnostic Tools
- Scan Tool Setup and Functionality
- Vehicle Check/Preparation
- Quick Test Description
- Clear the Continuous Diagnostic Trouble Codes (DTCs) and Reset the Emission Monitors Information in the Powertrain Control Module (PCM)
- Resetting The Keep Alive Memory (KAM)
- On-Board System Readiness (OSR) Test
- Output State Control (OSC)
- Output Test Mode (OTM)
- Parameter Identification (PID)
- Freeze Frame Data
- Flash Electrically Erasable Programmable Read Only Memory (EEPROM)
- Diagnostic Monitoring Test Results - Mode 6
- On Board Diagnostic (OBD) Drive Cycle
- Intermittent Diagnostic Techniques
- Adaptive Fuel Diagnostic Trouble Code (DTC) Diagnostic Techniques
- Notes
- Obtain Freeze Frame Data
- Using the LONGFT1 and LONGFT2 (Dual Bank Engines) PIDs
- Resetting Long Term Fuel Trims
- DTCs P0171/P0174 System Too Lean Diagnostic Aids
- Air Measurement System
- Vacuum Leaks/Unmetered Air
- Insufficient Fueling
- Exhaust System Leaks
- DTCs P0172/P0175 System Too Rich Diagnostic Aids
- Fuel System
- Air Inlet System
- Base Engine