Section 38 (Air Intake, Turbocharging -- 118 Chassis)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Basic Knowledge
- Boost Pressure Control, Basic Function - GF09.40-P-1000A
- Overrun Mode Bypass Air, Basic Function - GF09.40-P-1002A
- Temperature Sensor Upstream Of Exhaust Gas Turbocharger, Basic Function - GF09.40-P-2000A
- Basic Function Of Pressure Sensor Upstream Of Exhaust Gas Turbocharger - GF09.40-P-2001A
- Exhaust Gas Turbocharger, Basic Function - GF09.40-P-2200A
- Tightening Procedure For Exhaust Gas Turbocharger - GF09.40-P-8451-10MFH
- Exhaust-Gas Turbocharging, Basic Function - GF09.40-P-9900A
- Charge Air Cooling, Basic Function - GF09.41-P-1000A
- Charge Air Pressure And Temperature Sensor, Basic Function - GF09.41-P-2000A
- Electric Additional Turbocharging Compressor, Basic Function - GF09.50-P-1002A
- Boost Pressure Control Flap Actuator, Basic Function - GF09.50-P-2001A
- Safety Precautions
- Testing & Repair
- Remove/Install Air Intake Pipe Upstream Of Exhaust Gas Turbocharger - AR09.10-P-0003MFG
- Remove/Install Air Filter Housing
- Remove/Install Engine Intake Air Duct Downstream Of Air Filter - AR09.10-P-8130MFC
- Remove/Install Divert Air Switchover Valve
- Remove/Install Turbocharger - AR09.40-P-6020MFG
- Remove/Install Oil Return Flow Line Of Turbocharger
- Remove/Install Oil Feed Line For Turbocharger
- Remove/Install Turbocharger With Exhaust Manifold
- Remove/Install Heat Shield On Exhaust Gas Turbocharger - AR09.40-P-6045MFC
- Loosen/Tighten Screws/Bolts Of Charge-Air Distributor - AR09.41-P-0000-01MFG
- Remove/Install Low Temperature Circuit Expansion Reservoir - AR09.41-P-0001MFC
- Remove/Install Boost Pressure Sensor Upstream Of Throttle Valve - AR09.41-P-0003MFG
- Remove/Install Liquid Cooled Charge Air Cooler
- Remove/Install Low Temperature Circuit Switchover Valve - AR09.41-P-0130MFG
- Check Low Temperature Circuit Cooling System For Leaks - AR09.41-P-1010MFG
- Check Low Temperature Circuit For Leaktightness - AR09.41-P-1011MFC
- Open And Close Coupling - AR09.41-P-1311-01AL
- Tightening Procedure For Charge Air Manifold - AR09.41-P-1312-01MT
- Remove/Install Charge Air Pipe From Charge Air Cooler To Charge Air Distributor - AR09.41-P-1331MFC
- Remove/Install Charge Air Pipe Downstream Of Turbocharger
- Remove/Install Charge Air Pressure And Temperature Sensor Upstream Of Throttle Valve - AR09.41-P-2011MFC
- Remove/Install Charge Air Pressure And Temperature Sensor Downstream Of Throttle Valve - AR09.41-P-2012MFC
- Remove/Install Charge Air Cooler - AR09.41-P-6817MFD
- Drain/Fill Low Temperature Circuit Coolant
- Remove/Install Circulation Pump For Low Temperature Circuit
- Remove/Install Low Temperature Circuit Cooler
- Remove/Install Charge Air Distributor
- Remove/Install Boost Pressure Control Flap Actuator
- Test & Adjustment Values
- Maintenance
- Torque Specifications
- Forms
- Wiring Diagrams
- Special Tools