Caravan Control Unit Parameters Of Analog Outputs, Function - GF54.21-D-5026TSA

Model 907 

with code JA3 (Intelligent body control.) 

General 

Analog outputs are used to set voltage values to, for example, control a device that executes corresponding actions depending on the voltage applied to its input.

The MB Advanced Control control unit (N175) can operate 5 analog outputs.

Parameters, analog outputs 

The analog outputs can switch a maximum of 10 V and a minimum of 250 mV.

The analog outputs have a resolution of 100 mV and a tolerance of 200 mV.

The analog outputs can supply a maximum of 2 mA.

The load on the analog outputs must be greater than 5 kOhm.

As soon as the read voltage value does not match the output voltage, the MBAC switches off the analog output and creates an internal fault entry.